CALIBRA BACKFLASH STRIPED WINDOW DECAL 
 

(SIZES MAY VARY SLIGHTLY ACCORDING TO DESIGN DIMENSIONS BUT WILL NOT OFTEN EXCEED 1200mm length)
PRECISION CUT FROM TOP QUALITY VINYL WITH BACKING PAPER FOR EASY APPLICATION.

IF THIS DECAL IS TO BE STUCK TO THE INSIDE OF A WINDOW BUT TO BE VIEWED FROM THE OUTSIDE, YOU WILL WANT THE IMAGE IN MIRROR IMAGE. PLEASE SELECT YES OR NO TO MIRROR IMAGE OPTION IN THE DROP DOWN MENU.

A DECAL IS A STICKER CUT FROM (IN THIS CASE) ADHESIVE EXTERIOR GRADE VINYL. UNLIKE NORMAL STICKERS THERE IS NO BACKGROUND, JUST PRECISION CUT DESIGNS THAT ARE ON A BACKING PAPER SO THE SURFACE THAT THE DECAL IS BEING STUCK TO BECOMES THE BACKGROUND. THE PRE APPLIED TRANSFER TAPE IS USED TO LIFT THE DESIGN FROM THE BACKING PAPER (SO THE DESIGN STAYS IN ONE PIECE FOR APPLICATION). 
SIMPLY APPLY THE DECAL TO YOUR CHOSEN PLACE, AND RUB IT ON, THEN YOU CAN PEEL OFF AND DISCARD THE BACKING PAPER. JOB DONE!
 

HOW TO APPLY YOUR DECAL STICKER.

STEP 1

Thoroughly clean the area with alcohol or soap and water.
 

STEP 2

Prepare the sticker for application by firmly rubbing a squeegee or credit card across the transfer tape. This removes any air bubbles that may have formed and helps the sticker cling to the transfer tape.
 

STEP 3

Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.
 

STEP 4

Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 24 hours before moving to the next step.
 

STEP 5

Slowly peel the transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.

*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*For best results do not apply a sticker in extreme hot or cold temperatures.